Welcome to EnviroDIY, a community for do-it-yourself environmental science and monitoring. EnviroDIY is part of Home › Forums › Environmental Sensors › Couldn’t find DTS-12 turbidity sensor address › Reply To: Couldn’t find DTS-12 turbidity sensor address
I am using Mayfly v1.1. The turbidity sensor is connected with Screw Terminal.
I downloaded the zip from EnviroDIY_SDI12 using https://github.com/EnviroDIY/Arduino-SDI-12/archive/master.zip.
I am able to run the wiper with these:
|
1 2 3 |
Serial.println("Sending 0M2!"); mySDI12.sendCommand("0M2!"); delay(1000); |
Using this inside loop that runs every 30 seconds push the wiper. But, sending command to get data results in nothing.
while (mySDI12.available()) { Serial.write(mySDI12.read()); } This mySDI12.read() return nothing. I checked and see that all the wires are connected properly.
How do I do this? “set the jumper header next to the Grove jack to the 12v jumper setting? “. If my wiper which needs 12V is running well, doesn’t that mean it’s on 12V setting?
