Fiona

Hi All,

I had a station out for about a month and everything worked great until we had two stormy, cloudy days in a row. The voltage dropped too low to send data to Monitor My Watershed, and when we had consecutive sunny days, the station didn’t power back up and resume sending data to MMW. The station is located in an area that gets direct…[Read more]

Hi All,

We are in an area that experiences a 5-6 foot tidal range, and many of our sites are composed of salt marsh with soft, muddy substrate. Has anyone had any issues using the suggested rebar installation in this type of environment? I’d like to avoid the possibility of sediment burying our sensor setup and was curious if anyone had more…[Read more]

Hello,

Is it possible to add the Atlas Scientific conductivity 1.0 and industrial pH sensors to the available sensors in MonitorMyWatershed? I sent an e-mail directly to MMW a while back about the pH sensor but haven’t heard anything back. I understand these things take time but want to make sure it didn’t slip through the cracks.

Conductivity…[Read more]

Hi All,

I have everything I need to build out a system using the Mayfly and Atlas Scientific sensors, but I am stuck on how to integrate the Atlas Scientific code from menu a la carte into DRWI LTE. An electrical engineering volunteer created a shield that allows us to connect four sensors on their own electrically isolated carrier boards to the…[Read more]

Hello All,

I’m a beginner and am working on building a monitoring station using Atlas Scientific sensors and EZO circuits. I need to electrically isolate the circuits and connect my sensors via SMA connectors, and am looking for a carrier board that will meet these needs. I found this Whitebox Labs shield Whitebox T1 for Arduino – Whitebox Labs (…[Read more]