-
Braedon replied to the topic Negative Voltage Reading from Single-ended ADC Using Apogee SP-212-SS Sensor in the forum Environmental Sensors 1 years ago
Thank you for your reply! That definitely helped. I think the only thing I’m still confused on is the output channel. You mentioned that the white wire in the uppermost grove jack is connected to analog channel zero, but when I look at the board, the label next to that wire is AA1. If you could clear that up for me that would be great. Thanks for the help!
-
Braedon started the topic Negative Voltage Reading from Single-ended ADC Using Apogee SP-212-SS Sensor in the forum Environmental Sensors 1 years ago
I am trying to get shortwave radiation readings from an Apogee pyranometer (SP-212-SS model). I am new to electronics and microcontrollers, so there could be a lot of places I am going wrong here. I am using a Mayfly version 1.1 as the data logger. To connect the sensor, I am using the Aux Analog grove terminals. I’ve attached a picture of my…[Read more]
-
Braedon replied to the topic Mayfly v1.1 technical questions forum thread in the forum Mayfly Data Logger 1 years, 2 months ago
How do I switch over to the 12 volt power supply? The Board Features Overview page says the 5 and 12 volt circuits can be accessed from pin D22, but I am having trouble finding that pin. I notice there are some pins labeled Sw3, Sw5, and Sw12 at the bottom of the 20-pin headers. Is that where I switch the supply voltage, and if so, which pins am I…[Read more]
-
Braedon replied to the topic IDE and Mayfly not communicating in the forum Mayfly Data Logger 1 years, 2 months ago
It is working now! Thank you for helping me through that!
-
Braedon replied to the topic IDE and Mayfly not communicating in the forum Mayfly Data Logger 1 years, 2 months ago
I have swapped out the cable for one that has transmitted data for other devices and I am getting the same thing. My board receives power, but it doesn’t talk with my computer. The attached picture is what shows up on my device manager when I plug it in.
-
Braedon started the topic IDE and Mayfly not communicating in the forum Mayfly Data Logger 1 years, 2 months ago
I am having trouble getting my IDE/laptop and Mayfly to talk to each other. I have installed the EnviroDIY ATmega Boards package and have the EnviroDIY Mayfly 1284p selected as my active board. For my port, the option for COM3 is listed under the serial ports, and I have it selected. I have the data logger and my laptop connected with the USB-C…[Read more]
-
Braedon became a registered member 1 years, 2 months ago