Activity

Ah, perfect – thanks Sara!

The Arduino print function defaults to two decimal places for a float.  Normally, if you were using Serial.print(float) you could control the decimal places with Serial.print(float, decimalPlaces).  But because of the way the MS_DBG macro is written, that won’t work.  You’ll have to create a String from the number and then MS_DBG that:  MS_DBG(Stri…[Read more]

Hi @heather, Thanks for following up. All looks good to me!

Matt

Hi @mbarney, I’m combing through the forum topics with no replies, hoping to get some answers for folks, and found this one you posted last July. I’m sure you already discovered this, but the three example code links you listed no longer return 404s. Perhaps @srgdamiano was reorganizing the examples at the time?

• DRWI_CitSci.ino
• DRWI_LTE.ino

…

[Read more]

Thanks again Shannon!

found this

http://www.dfrobot.com/product-1073.html  TEL0073 Xbee TH BLUETOOTH 4.0  using Ti’s CC2540.  Digikey 1738-1014-ND‎

Seems to me there is a critical power issue;  how can a powered BT LE sleeping device plugged into a Mayfly,   wake a sleeping Mayfly once a remote BT LE beacon (cell phone) has been detected.  For the TEL0073 there is a mappin…[Read more]

James, it would be a good idea to search the issues on Monitor My Watershed’s GitHub to see if your problem has been previously reported. If it isn’t, and you are willing to create a new issue to make the development team aware, please do.

Haha, that worked! Thanks @mbarney.

I was curious whether opening Developer Tools (in Chrome) would show any insight to this problem. To my surprise, the Add Sensor button worked while I had DT open! One time I had to refresh the page while DT was open in order to get the Add Sensor dialog to display. Might be a workaround until the problem gets fixed.

@heather just FYI. I have attempted to do this on my work computer with the same result.

Is there somewhere I should log MMW problems? We often struggle with the timeseries viewer – it takes a long time to load. Is this a common problem? I thought perhaps it might be caused by our location (New Zealand).

Got it! Thanks Shannon!

I was reading up on the BLE support on the XBee3.  I think the only way to send data over Bluetooth is with Digi API frames.  You can use the on-board micropython, but from what I can tell, that uses the API frames under the hood.  So apart from having to figure out how to use the Mayfly to switch the XBee3 into API mode and properly ch…[Read more]

Right, that’s why I’m thinking you just need a screw terminal to Grove board, and since you only need 4 wires, you can use something like this:  https://solarbotics.com/product/29118/