Cheryl Nolan

Ok, thank you Shannon.

Thanks, I turned the solar panel hoping to get more sunlight.

I’m sorry for the duplication however I did several searches prior to posting but apparently I didn’t include the key words, nothing came up. I didn’t suspect the battery because of the issue with the dates changing from 9/26 to 9/24 on the display on the website as the last data dump…[Read more]

Yes, Neil I agree. I should have thought of that. There’s nothing being recorded so it would make sense that it’s the processor that failed. I do have a spare processor. I’ll have to try replacing it. That would probably be the easiest thing to try.
Thanks for your help. It’s greatly appreciated.

Hi Neil,

The unit is a water monitoring station that has a CTD (conductivity, temperature and depth) sensor in the stream, in a remote section of the stream’s headwaters and the electronics are in a Pelican Box on the stream bank, mounted to an iron pipe. (see photos below) The only wires coming out run from the pelican box to the sensor and from…[Read more]

Thanks Heather! I think I’ve got in now. 🙂

Thanks Heather! Sorry, I can’t keep all of the forums straight. 🙁

Just wanted to let the folks at Stroud know that I did finally get the Mayfly up and running and I was getting the data set directly to the Monitor My Watershed site. Thank you all for all of your help I couldn’t have done it without you! Now all I have to do is install it. It’s going on the Lackawanna River and is being co-located with the USGS…[Read more]

Great! Thanks Shannon!!

I have the Com Port coming up now but when I try to run the board temp or now sketches I get an error message “Invalid version ‘0.28.01’ for library in: C:UserscnolanDocumentsArduinolibrariesEnviroDIY_ModulatSensors” and the red light does not blink alternately with the green. I only get a blinking green light.

This is what I get when I copy the…[Read more]

Thanks, I was more than 3/4 of the way through the two 3-hour workshops that Shannon Hicks recorded and had all of the parts connected and all but the Interfacing With Monitor My Watershed and the Final Steps left to go when this happened. I had about 50 minutes of the 6 hour workshop to go. Everything was connected and working fine until I found…[Read more]

Is this what you’re looking for? I got an error on that too and I don’t have the board connected to the computer yet. I was just trying to do the first steps in the Arduino program.

Arduino: 1.8.12 (Windows 10), Board: “Arduino Uno”

Sketch uses 924 bytes (2%) of program storage space. Maximum is 32256 bytes.
Global variables use 9 bytes (0%) of…[Read more]