All content on EnviroDIY is licensed as Creative Commons Attribution-ShareAlike 4.0. Hardware designs on EnviroDIY are released under the CERN Open Hardware License 1.2. Alternative licenses are available. Learn about licenses and attribution
Welcome to EnviroDIY, a community for do-it-yourself environmental science and monitoring. EnviroDIY is part of WikiWatershed, an initiative of Stroud Water Research Center designed to help people advance knowledge and stewardship of fresh water. New to EnviroDIY? Start here
Community Activity See all activity
JK_WCCD started the topic Error Compiling for board EnviroDIY Mayfly 1284p in the forum Mayfly Data Logger 1 year, 8 months ago
Hello,
I am trying to upload the sketch through the following instructions (ModularSensors/examples/DRWI_NoCellular at master · EnviroDIY/ModularSensors · GitHub)
I followed all the directions but when I try to verify or upload the sketch through Arduino onto our Mayfly, I get the following error message –
<p style=”text-align: center;”>exit s…[Read more]
JK_WCCD became a registered member 1 year, 8 months ago
JK_WCCD
@jkimpawccd
Shannon Hicks replied to the topic Reading -9999 on all Sensors in the forum Mayfly Data Logger 1 year, 9 months ago
Have you tried measuring the voltage being applied to the sensors by using a voltmeter when the channel scanning sketch is running? For the turbidity sensor’s screw terminal board, put the voltmeter’s red probe on either of the V+ screws, and the black probe on either of the GND screws. For the CTD sensor’s 3.5mm headphone jack adapter board p…[Read more]
WFUWater replied to the topic Reading -9999 on all Sensors in the forum Mayfly Data Logger 1 year, 9 months ago
Hello, we’ve returned to try and set up the two sensors again but are still running into the issues of both being vacant at every location. We have tried both of them individually and have changed the 3.3v position to the 12v position for the Clarivue sensor. The Hydros is still connected to the 3.3v. We have also changed the sketch for the…[Read more]
neilh20 replied to the topic Artifactual troughs and flickers in recorded stream depth in the forum Monitor My Watershed 1 year, 9 months ago
@d_manning just wondering if you have had any insights 🙂
Rachel Frantz became a registered member 1 year, 9 months ago
Rachel Frantz
@rfrantz
Shannon Hicks replied to the topic Reading -9999 on all Sensors in the forum Mayfly Data Logger 1 year, 9 months ago
In your 4th picture, it looks like the Grove cable plug may not fully be seated in the grove jack. Not sure about any of the other ones since the angles in the photos didn’t show them well, but be sure that it’s pressed all the way into the jack. And your second photo shows that your two SDI12 Grove jack voltage selection jumpers are both set t…[Read more]
WFUWater replied to the topic Reading -9999 on all Sensors in the forum Mayfly Data Logger 1 year, 9 months ago
Here are a few pictures of our setup.
Shannon Hicks replied to the topic Reading -9999 on all Sensors in the forum Mayfly Data Logger 1 year, 9 months ago
Can you describe how you’ve connected the sensors to your Mayfly, there are multiple ways to do it correctly with the adapters we offer and even more if you’re doing it a non-traditional way. Better yet, could you take a pictures of your setup showing how you’ve connect each of the sensors to the Mayfly?
Coolbaugh Twp Water Monitoring Project became a registered member 1 year, 9 months ago
Coolbaugh Twp Water Monitoring Project
@coolbaughtwpeac