Community Activity

See all activity

• 

  Eric Booth replied to the topic Logging data from Milone eTape in the forum Environmental Sensors 1 weeks, 4 days ago

  Thanks for the response, Neil. I’m basing the idea that the sensor is calibrated on the following response from Milone when I asked about the difference between the standard voltage divider setup and the other more expensive (+$45) output modules:

  “<span data-olk-copy-source=”MessageBody”>If you go with the standard voltage divider, each sensor…[Read more]
• 

  neilh20 replied to the topic Logging data from Milone eTape in the forum Environmental Sensors 1 weeks, 5 days ago

  Hi Eric – I’ve purchased and looked at using the eTape.

  I was just wondering what made you think they are “calibrated” – that is the “0.0” markings relates to a defined voltage.  Usually this is shown for a calibrated sensor.  Similarly for a Full Scale relates to a known Voltage.?

  looking at the graphs,  they describe “0-5VDC Linear Re…[Read more]
• 

  neilh20 replied to the topic Abnormal power usage? in the forum Mayfly Data Logger 1 weeks, 5 days ago

  Hello Elliot, gosh too bad for the experience. Its a core issue of how to ensure there is enough power, and then also recover from low power events.  However to be able to get some help its best to post the details of the two systems.  Need to phrase the problem with enough detail that some one else might be able to comment.  Battery size and so…[Read more]
• 

  Eric Booth started the topic Logging data from Milone eTape in the forum Environmental Sensors 1 weeks, 5 days ago

  Hi –

  I am a newbie to the world of Arduino/MayFly and would like to create a system to regularly log the output from a Milone eTape sensor that will be installed on the side of a flume outdoors. This is the sensor: https://milonetech.com/shop/ols/products/xn-standard-etape-assembly-75a-a8ed96

  I have contacted Milone and it sounds like the…[Read more]
• 

  Eric Booth became a registered member 1 weeks, 5 days ago

  

  Eric Booth

  @egbooth

  View Profile
• 

  Shannon Hicks replied to the topic Only works when connected to the computer in the forum Mayfly Data Logger 2 weeks, 2 days ago

  What sensor(s) are you using with the board?  Have you reprogrammed the sketch onto the Mayfly recently, or are you using a board that was programmed last year or earlier?   Some people seems to be having issues with boards not sleeping/waking properly using the most recently SDI12 libraries, so if you’ve recently reprogrammed the board, then th…[Read more]
• 

  Jordyn MSUHydrogeology replied to the topic Only works when connected to the computer in the forum Mayfly Data Logger 2 weeks, 3 days ago

  Update, its still only working when connected, but its only doing one reading every time I plug it in.
• 

  Jordyn MSUHydrogeology started the topic Only works when connected to the computer in the forum Mayfly Data Logger 2 weeks, 3 days ago

  Hello Shannon,

  I hope you are doing well. It has been awhile since my last ask. I recently reset my system and now I am having an issue where the mayfly is only working when it is connected to my computer. Is this an issue with my battery?

   
• 

  Mrxbiker became a registered member 2 weeks, 3 days ago

  

  Mrxbiker

  @mrxbiker

  View Profile
• 

  Jess became a registered member 2 weeks, 6 days ago

  

  Jess

  @jcscholz11

  View Profile
• Load More