Reply To: No address detected for any sensor

Are the 3 solder jumpers on the back of your 6-pin screw terminal board soldered properly?  We noticed a few of them came from the factory with no solder on them, so I soldered them in the “Default” position before shipping them out, but there’s a chance yours might have been missed.  You can also try closing solder jumper SJ25 on the back of the Mayfly board to change the 12v boost converter to 9v output instead.  We found a few ClariVue sensors that apparently needed a little more power during the initial startup than the 12v boost converter can provide, and by setting it down to 9v that’ll send a little more current to the sensor and seems to give us better reliability.