-
Dale Drummond replied to the topic Mayfly with Xbee MTech mDot LoRa module in the forum Mayfly Data Logger 3 years, 3 months ago
Hi Shannon,
Thanks for the reply. I have tried every baud rate for the modemBaud setting. I just tried again with 115200. I get a slightly different response but unfortunately, it’s still not readable.
Waking up the Xbee Flushing the Serial port Check what band the module is set for. Sending command: AT+FREQ Response: Au%�UE Putting the Xbee to s…
-
Dale Drummond started the topic Mayfly with Xbee MTech mDot LoRa module in the forum Mayfly Data Logger 3 years, 3 months ago
Hello,
I’ve been working on getting a Mayfly working with an MTech mDot LoRa module. I cannot get any readable text back from the module even after trying all the different baud rates. Does anyone have this module working with their Mayfly? If so, can you share your sketch on the pin and board setup? I think I have everything configured…[Read more]
-
Dale Drummond replied to the topic Mayfly with LoRA module physical connection in the forum Mayfly Data Logger 3 years, 12 months ago
Hi Anthony,
I picked up a couple of the MultiTech mDotTM LoRa radio modules. Can you share any example code you have for getting them communicating? or do you need anyone to help test the ModularSensors library additions you are working on? I am happy to test and report back with any issues.
Thanks,
Dale
-
Dale Drummond replied to the topic Mayfly with LoRA module physical connection in the forum Mayfly Data Logger 4 years ago
Hi Anthony,
Thanks for your reply. I will have to check out the LoRa radios you suggested. I’ve been looking at the ModularSensors library as well. I’m am also checking with the project sponsor to see if there is a reason that specific LoRa radio module was chosen.
Thanks again!
Dale
-
Dale Drummond started the topic Mayfly with LoRA module physical connection in the forum Mayfly Data Logger 4 years ago
Hello,
I am working on a project that is trying to use the Semtech SX1272MB2DAS Shield LoRa transceiver for connectivity back to a Cisco LoRAWAN gateway. I was successful in getting the HYDROS-21 sensor reporting data correctly via the Mayfly serial port and writing to the SD card but I am having difficulty finding out how to physically connect…[Read more]
-
Dale Drummond became a registered member 4 years ago