-
aqua replied to the topic Connecting Arduino MEGA or NANO with Teros 12 Sensor in the forum Environmental Sensors 2 weeks ago
@shicks Thank you so much its working perfectly fine now. Also if you could explain to me how to convert the RAW data of the sensor with the units of measurement I want it would be really helpful.
-
aqua replied to the topic Connecting Arduino MEGA or NANO with Teros 12 Sensor in the forum Environmental Sensors 2 weeks, 6 days ago
@shicks Its working now. Thank you. But the issue is with the b_address_change sketch. This is the output.
13:12:30.112 -> ��fx������~��
���x�f~������怘�
f�f�f�f~~�ffx����憆���������f�~fxf���~����fx�������~f��x��������怘��f����f���~��x
��fx�����������f~f�fx怘�������ff���ff��fx��xx��fx���
���x���fx�������~��xfx��~��x
��fx���怘�f��fx�f�~��x
��fx����怘 -
aqua replied to the topic Connecting Arduino MEGA or NANO with Teros 12 Sensor in the forum Environmental Sensors 2 weeks, 6 days ago
@shicks When I connect the tip-power, ring-ground, and sleeve-data Arduino IDE can’t read my port & the light on the Arduino Mega stops. What’s the reason? This is the output its giving me ”
<div>12:06:33.721 -> Timeout value:
</div>
<div>12:06:33.721 -> -9999
</div>
<div>12:06:33.721 -> Powering up sensors,…
-
aqua replied to the topic Connecting Arduino MEGA or NANO with Teros 12 Sensor in the forum Environmental Sensors 2 weeks, 6 days ago
@shicks I had a doubt related to the baud rate mentioned in the example sketches which is “115200” but for SDI-12 configuration of TEROS 12 its “1200”. Should I change it? Also if I change the address of the sensor will I be able to obtain data from the data logger provided by METER or do I have to set it to “0” each & every time I have to access…[Read more]
-
aqua replied to the topic Connecting Arduino MEGA or NANO with Teros 12 Sensor in the forum Environmental Sensors 3 weeks, 6 days ago
@shicks For now I want to connect one Teros 12 but in future want to connect four. Also I have both Mega & Nano with me. The output is an audio jack for which I have bought a trs 3.5mm breakout board. I just want to display the sensor data on my computer & use a esp module to display it on some website for future purposes
-
aqua replied to the topic Connecting Arduino MEGA or NANO with Teros 12 Sensor in the forum Environmental Sensors 3 weeks, 6 days ago
can you suggest something?
-
aqua started the topic Connecting Arduino MEGA or NANO with Teros 12 Sensor in the forum Environmental Sensors 3 weeks, 6 days ago
I’m new when it comes to SDI-12 sensors. Can someone help me connecting Arduino Mega or Nano to the Teros 12. A basic pin configuration & which code to run to check whether the data is being read would be really helpful.
-
aqua became a registered member 4 weeks ago