Welcome to EnviroDIY, a community for do-it-yourself environmental science and monitoring. EnviroDIY is part of WikiWatershed, a web toolkit designed to help citizens, conservation practitioners, municipal decision-makers, researchers, educators, and students advance knowledge and stewardship of fresh water. New to EnviroDIY? Start here

Reply To: Bringing in serial data through UART on 20-Pin connector

Home Forums Mayfly Data Logger Bringing in serial data through UART on 20-Pin connector Reply To: Bringing in serial data through UART on 20-Pin connector

#14191
Kurt Rosenberger
Participant

    Hi Shannon and Sara

    Thank you for your replies – yes, I was not able to communicate with the Mayfly while I had data coming in, so I will switch to RX1/TX1. However, I’m still not clear on how to designate that in the initial setup in the sketch. It was fine with A6 and A7, but when I try to use A8/A9 or RX1/TX1 in the ‘static const’ declaration, it won’t compile. Attached is the example sketch I’m using. Thanks again for your help

    Attachments: