Welcome to EnviroDIY, a community for do-it-yourself environmental science and monitoring. EnviroDIY is part of Home › Forums › Environmental Sensors › SDI-12 Change Address for Meter Hydros 21 CTD Sensor › Reply To: SDI-12 Change Address for Meter Hydros 21 CTD Sensor
2019-08-14 at 9:46 AM
#13070
Update…
After some searching on other forums it seems the sketch upload error is just a communications error. Is there any reason why I have previously been able to upload sketches to my board a
After some searching on other forums it seems the sketch upload error is just a communications error. Is there any reason why I have previously been able to upload sketches to my board a
Update…
After some searching on other forums it seems the sketch upload error is just a communications error. Is there any reason why I have previously been able to upload sketches to my board and send output to the serial monitor, but now I cannot? Could it be a driver issue?
After some searching on other forums it seems the sketch upload error is just a communications error. Is there any reason why I have previously been able to upload sketches to my board and send output to the serial monitor, but now I cannot? Could it be a driver issue?
I did not install the FTDI virtual COM port (VCP) driver because when I first connected the Mayfly to my PC it was recognized… my IT dept said that I already had the necessary driver installed. Perhaps this is not the case?
