Welcome to EnviroDIY, a community for do-it-yourself environmental science and monitoring. EnviroDIY is part of Home › Forums › Mayfly Data Logger › Trouble initializing XBee3 LTE-M › Reply To: Trouble initializing XBee3 LTE-M
2019-01-25 at 2:05 PM
#12747
Neil’s right about the symbol – it’s a reset-not pin – pull it low to reset.
But… it’s not connected to anything else on the board, so you can’t pull it in a
Neil’s right about the symbol – it’s a reset-not pin – pull it low to reset.
But… it’s not connected to anything else on the board, so you can’t pull it in any direction without some hacking. You could use the pin stubs on the back of the board to solder on a wire to connect the bee reset pin to some processor pin. The Digi documentation recommends putting a capacitor near the reset pin to prevent any resets from noise.
