-
Eric Booth replied to the topic Logging data from Milone eTape in the forum Environmental Sensors 2 days, 2 hours ago
Sorry for the delay. I’m planning to use it in an H-flume that has a maximum depth of 0.45 meters. It looks like precision is listed as 0.25 mm but I’m okay with accuracy closer to 2 mm.
And thanks for the sensor range info. I’ll plan to install the eTape in a probe well attached to the flume that extends below the flume entrance elevation. I…[Read more]
-
Eric Booth replied to the topic Logging data from Milone eTape in the forum Environmental Sensors 1 weeks, 2 days ago
Thanks for the response, Neil. I’m basing the idea that the sensor is calibrated on the following response from Milone when I asked about the difference between the standard voltage divider setup and the other more expensive (+$45) output modules:
“<span data-olk-copy-source=”MessageBody”>If you go with the standard voltage divider, each sensor…[Read more]
-
Eric Booth started the topic Logging data from Milone eTape in the forum Environmental Sensors 1 weeks, 3 days ago
Hi –
I am a newbie to the world of Arduino/MayFly and would like to create a system to regularly log the output from a Milone eTape sensor that will be installed on the side of a flume outdoors. This is the sensor: https://milonetech.com/shop/ols/products/xn-standard-etape-assembly-75a-a8ed96
I have contacted Milone and it sounds like the…[Read more]
-
Eric Booth became a registered member 1 weeks, 3 days ago