Activity – BrianJastram

BrianJastram started the topic Data Gap When Voltage is Low in the forum Mayfly Data Logger 6 years, 3 months ago

When my Mayfly voltage is <3.65 it is programmed to just log data and not publish (to MMW via DigiXBeeCellular)? When the voltage is good again why doesn’t it send all the data that were logged in the interim? This is a remote site so I haven’t checked to see if the data are on the SD card. The logging interval is 5 min. (I’m planning to increase…[Read more]

BrianJastram replied to the topic GPRSBee in the forum Mayfly Data Logger 6 years, 10 months ago

Dave,

I bought the PulseLarson W3554B0140 RF ANT 829MHZ/2.2GHZ PCB TRACE (https://www.digikey.com/products/en?keywords=553-2574-ND) and I’m pretty sure it works. It looks like the one that comes with the Development kit (https://www.digi.com/products/models/xk3-c-n1-ut-e).

BrianJastram replied to the topic GPRSBee in the forum Mayfly Data Logger 6 years, 10 months ago

mdean,

I want to try those things but don’t have enough experience yet to know exactly how. When you reference TinyGSM (increasing the timeout time) what exactly do you mean by TinyGSM? And defining the modem serial at 9600 is understandable except I don’t see where to do that (in my logging_to_EnviroDIY sketch or in a different sketch that sets…[Read more]

BrianJastram replied to the topic GPRSBee in the forum Mayfly Data Logger 6 years, 10 months ago

Cal,

I have the hardware:

Mayfly Datalogger v0.5b
Digi XBee3 Cellular Lte-M/NB-Iot – XB3-C-A2-UT-001
No antenna – 3 bars of AT&T on my iphone
Soldered SJ13 and cut trace BEE-Vcc to 3v3 – 4.19V between Bee pins 1 and 10
3.7v Lipo battery
Solar panel from mayfly startup kit
USB to Windows PC – XCTU installed but not implemented
Hologram SIM…[Read more]

@brianjastram