All content on EnviroDIY is licensed as Creative Commons Attribution-ShareAlike 4.0. Hardware designs on EnviroDIY are released under the CERN Open Hardware License 1.2. Alternative licenses are available. Learn more
Welcome to EnviroDIY, a community for do-it-yourself environmental science and monitoring. EnviroDIY is part of WikiWatershed, an initiative of Stroud Water Research Center designed to help people advance knowledge and stewardship of fresh water. New to EnviroDIY? Start here
Community Activity See all activity
zackmeuth became a registered member 1 months ago
zackmeuth
@zackmeuth
Scott Ensign wrote a new post 1 months, 1 weeks ago
EPA Publishes EnviroDIY-Based Monitoring Results
The U.S. Environmental Protection Agency has come full circle with EnviroDIY and the Mayfly Data Logger. A team of EPA scientists developed a roof […]
neilh20 commented on the post, Monitor My Watershed: New Release! 1 months, 2 weeks ago
Thanks for the update and the details. There’s so much work goes into the infrastructure for a remote automated monitoring device—the software releases being part of it. Thanks so much for detailing it. One o […]
Scott Ensign replied to the topic Can't Upload Data "This file corresponds to another site." in the forum Monitor My Watershed 1 months, 2 weeks ago
Instructions for uploading csv data to Monitor My Watershed are in section 7 of the Monitor My Watershed Sensor Data Manual. Note that there are different instructions for “Uploading EnviroDIY Monitoring Station Data – Filling Data Gaps” and “Uploading CSV Sensor Data Not Already Formatted for MonitorMW”.
Shannon Hicks replied to the topic Could not wake modem for clock sync in the forum Mayfly Data Logger 1 months, 3 weeks ago
What sketch are you running? The debug statements above are mentioning Digi Xbee module, but your photo shows a Simcom SIM7080 module. The code for a Digi Xbee modem is not compatible with the Simcom module shown in the photo.
If you’re trying to use the configuration shown in the photo, along with a Hyrdos 21 CTD sensor (as indicated in your c…[Read more]
Tom Clark replied to the topic Could not wake modem for clock sync in the forum Mayfly Data Logger 1 months, 3 weeks ago
Hi Sara and Shannon,
I am also getting the “could not wake modem for clock sync” error. I do not know if it’s connected but when the logger records to the SD card (after giving the “could not wake modem for clock sync” error) it records at random time intervals and only takes a few data points before stopping.
Here is the debugging information I…[Read more]
Scott Ensign wrote a new post 1 months, 3 weeks ago
Monitor My Watershed: New Release!
The Monitor My Watershed development team is excited to announce the release of Monitor My Watershed V0.18. Performance Enhancements This new […]
rfenster became a registered member 1 months, 4 weeks ago
rfenster
@rfenster
neilh20 replied to the topic Primary powering in cold settings in the forum Infrastructure and Equipment 1 months, 4 weeks ago
Well as you can see this thread is almost 3 years old. I haven’t tried anything more than what was mentioned above. Your analysis is solid however its dealing with any current pulses and battery voltage measurement circuit.
neilh20 replied to the topic POST monitormywatershed.org in the forum Monitor My Watershed 1 months, 4 weeks ago
I’ve had some response from staging.monitormywatershed.org:80
but then it seems to become unreliable.
https://github.com/WikiWatershed/monitor-my-watershed/issues/752